How to adjust the film thickness for LM6-330

◉ For LM6-330

Use this function to adjust your film thickness as you needed, there are 7 optional mode for your choice, try different mode to laminate your papers.

How to adjust the anvil of Rayson's series saddle heavy duty stapler

◉ For SH-03

the staples can not formed well or broken while stapling, mostly because the anvil was moved, it have to be adjusted.

How to replace the spring for RAYSON SH-03 heavy duty stapler

◉ For SH-03

The spring will lose the elasticity after deforming, it must be replaced.

How to replace the punching plate for RAYSON SH-03 heavy duty stapler

◉ For SH-03

After the punching plate was worn, the staple will be difficult to pushing out and will be deformed during stapling, then it must be replaced.

How to replace the slide block for RAYSON SH-03 heavy duty stapler

◉ For SH-03

While using the slide block, the slide block will be broken or the screw will be slipping , it must be replaced.

How to replace the heaters for RAYSON LM Series Laminator

◉ For LM Series Laminator

While the heater or the heating coil broken, the heaters must be replaced

How to replace the circuit board (PCB) for RAYSON LM Series Laminator

◉ For LM Series Laminator

While the circuit board (PCB) does not work, it must be replaced.

How to Replace the Roller for RAYSON LM Series Laminator

◉ For LM Series Laminator

When the rollers cracked and uneven, it cannot be used anymore, the rollers must be replaced

How to Replace the motor for RAYSON LM Series Laminator

◉ For LM Series Laminator

When the rollers did not rotate but it can be heated up. This should caused by the motor’s problem, then must to replace it.

How to adjust the roller pressure of Rayson LM series laminator

◉ For LM Series Laminator

During to using the laminator, the pressure should to be adjusted according to the different thickness of the laminating film.

How To Clean The Roller Of Rayson LM Series Laminator

◉ For LM Series Laminator

The daily maintenance of the laminator is to clean the rollers ensure the surface of the rollers flat and tidy.